COLORNICE

Plastic Interior Paint

Acrylic resin-based, matte finish decorative interior plastic paint.

SUITABLE AREAS FOR USAGE

  • Applied as a topcoat in all interior spaces.
  • For both horizontal and vertical applications.
  • Can be used on plaster, gypsum board, putty, fiber cement, OSB, and paintable wallpaper after appropriate priming.
  • Used on faded old painted surfaces.
PRODUCT SPECIFICATIONS:
  • It has a breathability feature.
  • It is water-based and does not cause odor.
  • It integrates with the surface thanks to its high strength.
  • It has excellent covering ability.
  • It is easily applied by roller and spray.
  • If applied correctly, it will not cause shedding or swelling.
APPLICATION
  • COLORNICE is applied to the facade in two coats using a brush, roller, or a single coat of spraying.
  • Before applying COLORNICE interior paint, the correct water additive ratio must be adjusted, and the consistency must be achieved.
  • The dilution ratio of interior surface paint with water should be approximately 15% to 20%.
  • Two coats are recommended for the finish, and the waiting time between coats is 5 to 8 hours.
  • Touch dry time is 30 to 60 minutes.
  • Complete drying time is 24 hours.
  • During application, care should be taken to ensure that the ambient temperature is between +5°C and +30°C.
STORAGE, PACKAGING, CONSUMPTION
  • It should be stacked up to 4 times in its original packaging.
  • It should be stored in a closed area.
  • Necessary precautions must be taken against water, humidity, frost, and severe weather conditions.
  • It should be stored on a pallet and in a dry place between +10°C and +25°C.
  • Punctured, opened, and burst buckets should be closed or used immediately.
  • If the specified storage conditions are observed, the storage life is 24 months.
  • COLORNICE washable paint is offered in different packaging forms and is available in 5lt/7.5lt/15lt bucket options.
  • Depending on the application technique and the absorbency of the surface; the consumption rate is 13-18 m²/lt in a single coat.
  • A controlled sample is recommended for exact consumption.
  • The specified rates are theoretical standards and may vary depending on the application method and intensity of use.
WARNINGS
  • The recommended dilution rate should be applied and adhered to.
  • In applications with length and continuity, care should be taken to ensure that the thinning is done at the same rate to avoid tonal differences.
  • It should not be brought into contact with skin, eyes, and mouth, and the application should be carried out by taking the necessary work safety precautions.
  • Avoid applying at temperatures below +5°C and above +35°C, and do not try to use frozen material by adding water.
DOCUMENTS
Click for document