PLASTIK KOVA ASTAR CORUCONTACT PLUS CONCERTE LINING

CORUCONTACT PLUS

Exposed Concrete Primer

It is an acrylic resin based interior and exterior primer used to increase surface adhesion before applying gypsum and cement based plaster on exposed concrete.

SUITABLE AREAS FOR USAGE

  • It is used as an adhesion enhancer on surfaces such as exposed concrete,
  • Exposed concrete,
  • Wall,
  • Column, Ceiling before applying gypsum and cement based mortar on exposed concrete surfaces.
PRODUCT FEATURES
  • It has high adherence.
  • It has excellent adhesion strength and adheres perfectly even to old coatings.
  • It is elastic and does not crack.
  • It can be easily applied with airless spray or roller.
  • It is resistant to water and chemical materials.
  • It penetrates the surfaces very well.
  • Does not collapse.
  • Ready to use, in liquid form
APPLICATION
  • It is a ready-made material and is applied by diluting it by 50-60%.
  • The material should be applied after it is mixed very well.
  • Gloves should definitely be used during application.
  • It is applied by spraying, brush or roller.
  • It should not be applied in rainy weather or at temperatures lower than (+) 5°C.
STORAGE, PACKAGING, CONSUMPTION
  • It should be stacked up to 8 times in its original packaging.
  • It should be stored in a closed area.
  • Necessary precautions must be taken against water, humidity, frost and severe weather conditions.
  • It should be stored on a pallet and in a dry place between +5°C and +25°C.
  • Punctured, opened and burst buckets should be closed or used immediately.
  • CORUCONTACT PLUS is available ready to use as a liquid in 12 kg and 15 kg buckets.
  • It is produced in green and brick red, please consult your representative for different colors.
  • Consumption rate varies depending on the application technique and the absorbency of the surface.
  • A controlled sample is recommended for exact consumption.
  • The specified rates are theoretical standards and may vary depending on the application method and intensity of use.
WARNINGS
  • The newly applied material should not be exposed to rain or frost for 24 hours. It should not be applied in rainy weather below (+) 10°C.
  • It should not be applied to wet and frozen surfaces.
  • Pay attention to the safety signs and warnings on the packaging.
  • Adequate ventilation should be provided in workshops, and open flames and high temperatures should be avoided.
  • Mix well before application.
  • Do not leave the lid of the packaging open.
  • Avoid application in weather conditions where rain is expected or under rain.
  • It should not be brought into contact with skin, eyes and mouth, and the application should be carried out by taking the necessary work safety precautions.
  • Avoid applying at temperatures below +5°C and above +35°C, and do not try to use frozen material by adding water.
DOCUMENTS
Click for document