SILICOPAINT SILICONE MATTE

UV-Resistant Matte Exterior Paint

A water-based, silicone-added matte finish topcoat exterior paint with high coverage and breathability.

SUITABLE AREAS FOR USAGE

  • Used as a topcoat in all exterior applications.
  • Applicable on plaster and exposed concrete surfaces.
  • Used on faded old painted surfaces.
PRODUCT SPECIFICATIONS
  • It has water repellent properties thanks to its silicone structure.
  • It integrates with the surface thanks to its high strength.
  • It is resistant to UV rays and does not fade.
  • It is resistant to severe climatic conditions.
  • It spreads easily on the surface thanks to its silicone additive.
  • It has excellent covering ability.
  • It is easily applied by roller and spray.
  • If applied correctly, it will not cause shedding or swelling.
APPLICATION
  • SILICOPAINT SILICONE; is applied to the facade in two coats by brush, roller or by spraying in one coat.
  • Before applying SILICONE MAT, the correct water additive ratio must be adjusted and the consistency must be achieved.
  • The dilution ratio of exterior paint with water has been tested at approximately 10%, which is the recommended amount.
  • Two coats are recommended for the finish and the waiting time between coats is 12 hours.
  • Touch dry time is 1 to 2 hours.
  • Complete drying time is 24 hours.
  • During application, care should be taken to ensure that the ambient temperature is between +5°C and +30°C.
STORAGE, PACKAGING AND CONSUMPTION
  • It should be stacked up to 3 times in its original packaging.
  • It should be stored in a closed area.
  • Necessary precautions must be taken against water, humidity, frost and severe weather conditions.
  • It should be stored on a pallet and in a dry place between +10°C and +25°C.
  • Punctured, opened and burst buckets should be closed or used immediately.
  • If the specified storage conditions are observed, the storage life is 24 months. SILICONE, offered in different packaging forms, is offered in 5lt/7.5lt/15lt bucket options.
  • Depending on the application technique and the absorbency of the surface, the consumption rate is 6 to 10 m2/lt in a single coat.
  • A controlled sample is recommended for exact consumption.
  • The specified rates are theoretical standards and may vary depending on the application method and intensity of use.
WARNINGS
  • The recommended dilution rate should be applied and adhered to.
  • In applications with length and continuity, care should be taken to ensure that the thinning is done at the same rate to avoid tonal differences.
  • On surfaces that have or are at risk of salt efflorescence, it is recommended to clean the surface with a damp brush and then apply a mixture of 1 part surface impregnation material and 1 part water to the surface with a brush before applying the primer.
  • It should not be brought into contact with skin, eyes and mouth, and the application should be carried out by taking the necessary work safety precautions.
  • Avoid applying at temperatures below +5°C and above +35°C, and do not try to use frozen material by adding water.
DOCUMENTS
Click for document