Coru Pucoat 2 SKB
CORU PUCOAT II SKB
Polyurethane Based Two Component Matte/Glossy Finishing Paint
liphatic Finishing Paint CORU PU COAT II SKB; It is an aliphatic polyurethane based, UV resistant two component matte or glossy finishing paint that can be applied to concrete and metal surfaces in interior and exterior spaces. (Coru PuCoat II SKM-Matte) (Coru PuCoat II SKP - Glossy)
Suitable Areas of Application
- On concrete or metal surfaces,
- On PU and epoxy coated surfaces,
- In industrial steel structures,
- In production and storage areas, garages, hangars and loading ramps
- In parking lots,
- In open sports fields,
- In tennis courts,
- In data processing and control rooms, it can be used as a final floor and wall paint.
- Resistant to aging, water and sea water, salt and many chemicals, outdoor weather conditions, weak acids and bases.
- Resistant to scratches and abrasions.
- High ultraviolet stability. Does not cause chalking or color change.
- Suitable for sterile conditions. Hygienic. Easy to clean.
- Provides impermeability to the surface it is applied to.
FEATURES
- It is resistant to aging, water and sea water, salt and many chemicals, external weather conditions, weak acids and bases.
- It is resistant to scratches and abrasions.
- It has high ultraviolet stability. It does not cause chalking or color change.
- Suitable for sterile conditions. Hygienic. Easy to clean.
- It provides impermeability to the surface on which it is applied.
APPLICATION
- Mix each component separately before mixing components A and B.
- After adding component B to component A, mix continuously with a low speed mixer for 3 minutes until a homogeneous mixture is obtained.
- Avoid over-mixing to minimize air entrainment.
- The mixture is applied to the prepared surface with a merino roller.
- The first layer can be thinned with 10% cellulosic thinner. The wet film thickness of each layer should not exceed 100 microns.
- Applying two coats in total is sufficient.
- It is very important to apply the second coat within the correct application time. Otherwise, adhesion between layers will decrease and peeling may occur.
- If the edges meet each other while wet during application, a seamless surface can be achieved.
STORAGE, PACKAGING, CONSUMPTION
It can be stored for a minimum of 8 months in unopened packaging at 35°C. It should be protected from frost. It should be applied in at least two layers, with 0.600 kg/m2 for each layer.
DOCUMENT
