Waternot

WATERNOT is plug powder which contains mineral filler, special cement and polymer, catalyzer additive.

APPLICATION AREAS

Interiors and exteriors.
Urgent applications in the leaks of pressure water.
In the prevention and blockage of seepage before waterproofing.
In the jointing of concrete and bricks.
In the curtain walls, basements, and tunnels.
In the urgent blockage of active water leakage of the reservoirs, lift shafts and damaged concrete pipes.
Used to block the active water leakage in the cracks and holes.
In the application of impermeability in the construction jointing, sewer jointing, reservoirs and other water stopping areas.
on the all horizontal and vertical surfaces.

PRODUCT SPECIFICATIONS:

SURFACE PREPARATION

Do not create cutting edge.
preferably, the corners of the cracks and holes should be cut and removed in at least 20mm in square form.
To remove all soft particles, dusts and remnants, wash the cracks and holes with pressure water.
All the areas should be moisturized before WATERNOT application.
The layers such as oil, dirt, paint, cement and efflorescence that reduce the adherence should be cleaned well.

APPLICATION

1 scale of water and 2,5/3 scale WATERNOT are mixed until it becomes homogenous.
Keep in your hand until you feel slight heat and hardening (Wearing gloves is necessary).
The product made pulpwood is applied by pressing for approximately 1-2 minutes in the area of leaking.
If the leaking area is big enough not to be covered with 0,5 kg WATERNOT, by following the process order, it should be done from center to the corners.
After blocking the active water leaking, continue with finishing cut backward.

Open the cross section in 20mm width and depth, and clean the dirt and scraps.
Apply the WATERNOT mortar to the prepared section and level the area.
While filleting, create concave cavity or corner with 45°C angle.
The process of solidification ends in 2-4 minutes. When the applied WATERNOT is hardened enough, moisturize with clean water and keep this moisture for at least 15 minutes.

PACKAGING AND CONSUMPTION

CORUWHITE is available in 5KG bucket as powder.
According to the application technique and the absorber of the surface, the rate of consumption is variable.
For exact consumption, controlled sample is recommended
The proportions given here are just theoretical and may be changed depending on the application techniques.

STORAGE

Six times as much piling as can be done in original packaging.
Keep in dry and indoor places.
Please take necessary precautions against extreme weather conditions, water, humid and frost
Keep in temperatures between +10 and +25 Celsius degree and dry places.
Faulty bucket or package should be untouched and returned
If the warehouse conditions are proper, storage life is 12 months.

WARNINGS

Waterproofing should be done after the leak is blocked with WATERNOT.
New applications must be protected from rain and frost for 24 hours.
Pay attention to safety signs and warnings on the package.
Keep under enough air conditioning level. Prevent from fire and high temperature.
Blend well before the process. Do not keep the package open.
During the rain and under the possibility of rain, do not apply.
Avoid any contact with skin, eyes, and mouth and take necessary work safety procedures.
Do not apply at the temperatures under +10°C and above +30 °C and do not use frozen material by adding water.
Our company, CORUNEX, takes no responsibility for the consequences of wrong applications which ignore warnings and instructions.

DOCUMENTS