Corunex Thioseal Premier

Polysulphide Based Primer

A single component, resin-solvent based high adherence primer.

Suitable Areas of Application

Applied to absorbent surfaces such as concrete, screed and plaster.
Used in places where polysulphide paste is used, especially in concrete joints, to ensure better adhesion of concrete and paste.

APPLICATION

Both sides of the joints are taped to prevent primer contamination.
THIOSEAL PREMIER is applied to both sides of the joint with a clean brush and the tapes are removed.
Wait for the primer to dry completely.
Joint depth is limited with PE-based wick or similar.
Then, polysulphide based joint filler is applied.

STORAGE, PACKAGING, CONSUMPTION

It should be stacked up to 2 layers in its original packaging.
It should be stored in a closed area.
Necessary precautions must be taken against water, humidity, frost and severe weather conditions.
It should be stored on a pallet and in a dry place between +10°C and +25°C.
Punctured, opened and burst buckets should be closed or used immediately.
If the specified storage conditions are observed, the storage life is 12 months.
Consumption is 0.150-0.200 kg/m2. Packaging is 1 kg tin can.

SAFETY AND WARNINGS

It is not suitable for use under pressurized water, on glass and glazed surfaces, underground where there is high hydrostatic pressure, or on paint.
Freshly applied material should not be exposed to rain or frost for 24 hours.
CORUPU LINE should not be applied in rainy and foggy weather below (+) 5°C. It should not be applied to wet and frozen surfaces.
Pay attention to the safety signs and warnings on the packaging.
The health and safety information specified in the Product Safety Data Sheet (MSDS) prepared by a certified technical team in accordance with international standards (ECDirective 2001/58/EC) regarding the product must be followed.
Adequate ventilation should be provided in workshops, and open flames and high temperatures should be avoided.
Stir well before application. Do not leave the lid of the package open.
Avoid application in weather conditions where rain is expected or under rain.
It should not be brought into contact with skin, eyes and mouth, and the application should be carried out by taking the necessary work safety precautions.
Avoid applying at temperatures below (+) 5°C and above (+) 30°C, do not try to use frozen material by adding water to it.

DOCUMENT