Corunex Thioseal

Polysulfide Sealant (Horizontal)

It is a two-component liquid polymer (polysulfide) based, very highly elastic fluid joint sealant that cures in the presence of a catalyst.

Suitable Areas of Application

High movement capacity, durability that can maintain its properties for a very long time even under severe weather conditions and resistance to chemicals in buildings and all other structures that require very high flexibility.
It is used as a joint sealant in horizontal expansion joints.
In the automobile industry,
It is used as an assembly material in marine vehicles to fill holes and joints and to insulate against external environmental conditions

APPLICATION

Care should be taken not to create air bubbles in the mixture during mixing. The mixture should be used within 1 hour at the latest after preparation.
Application is done using a gun and applicator suitable for the packaging type.
If the joint depth is large, the joint depth should be adjusted with appropriate profiles to save material.
Use of primer to improve adhesion.

STORAGE, PACKAGING, CONSUMPTION

It should be stacked up to 8 times in its original packaging.
It should be stored in a closed area.
Necessary precautions must be taken against water, humidity, frost and severe weather conditions.
It should be stored on a pallet and in a dry place between +10°C and +25°C.
Punctured, opened and burst buckets should be closed or used immediately.
If the specified storage conditions are observed, the storage life is 12 months.
WATERNOT is produced in 5 kg powder form in a bucket.
Consumption rate varies depending on the application technique and the absorbency of the surface.
A controlled sample is recommended for exact consumption.
The specified rates are theoretical standards and may vary depending on the application method and intensity of use.

SAFETY AND WARNINGS

After preventing leakage by using WATERNOT, waterproofing should be done on it.
Freshly applied material should not be exposed to rain or frost for 24 hours.
Pay attention to the safety signs and warnings on the packaging.
Adequate ventilation should be provided in workshops, and open flames and high temperatures should be avoided.
Mix well before application.
Do not leave the lid of the packaging open.
Avoid application in weather conditions where rain is expected or under rain.
It should not be brought into contact with skin, eyes and mouth, and the application should be carried out by taking the necessary work safety precautions.
Avoid applying at temperatures below +10°C and above +30°C, do not try to use frozen material by adding water.

DOCUMENT